Available Inventory

2016 Cusco Industrial Vac

Click Image to Enlarge

General Details:

EQ #:11513
VIN #:2NP3LJ0X6GM285624
Chassis:
2016 Peterbilt 348
Engine:
Cummins ISL-9
Vacuum System:
Moro PM200 Pump
GAWR:
60,000 lbs

Specifications:

2016 CUSCO DOT INDUSTRIAL VAC, EQ# 11513

TANK CAPACITY:
3150 USG + 3% Outage

DESIGN:
Design shall withstand25-PSI internal pressure and 15 PSIG external pressure (full vacuum) and shall meet all the requirements of Section VIII Division 1 of the A.S.M.E. Boiler and Pressure Vessel Code. National Board Registered. Tank to be designed and constructed in full compliance with Department of Transportation Specification DOT407/412

HEAD MATERIAL:
0.3125 SA516-70

SHELL MATERIAL:
0.3125 SA516-70

TANK DIAMETER:
72" OD

OPERATING TEMPERATURE:
-20 to 200 degrees F

HYDROSTATIC TEST PRESSURE:
40.0 PSIG

PRESSURE RELIEF:   
4" SS Girard pressure vent, 25 PSIG setting mounted top of tank.

PRIMARY SHUT-OFF:
4" internal shut-off with 6" SS float ball and cage assembly with neoprene rubber seat top front of tank.

BAFFLE:
One anti-surge mounted on reinforcing pad.

RINGS:
Circumferential reinforcement rings with tank support feet.

OVERTURN PROTECTION:
Front, center, and rear 4" pipe construction overturns with reinforcement pads and gussets

LIQUID LEVEL INDICATOR:
Stainless Steel construction rotary float gauge with 6” float ball assembly located on front drive side with grab handle and up position tie back.
   
REAR DOOR:
Hydraulic full opening rear door assembly with 6 heavy duty door bolts, neoprene rubber rear door gasket, double acting hydraulic cylinder and safety brace.

SUCTION VALVE:
4" Betts air operated with 4” sand pipe / deflector plate assembly, and aluminum Kamlok fittings mounted on rear head.

DISCHARGE VALVE:   
6" ANSI Betts air open/spring close valve and Betts actuator with aluminum Kamlok fittings mounted on rear head.

ISOLATION VALVE:
4” air operated butterfly valve between primary and secondary shut-off with PTO interconnect.

MUFFLER:
4" muffler / oil trap assembly with drain valve, 12" swing out bottom clean out and 4" exhaust adapter.

PIPING:   
Single 4" diameter no disconnect piping to allow tank to dump with vacuum system connected with vacuum pump flush port and wire reinforced rubber hose.

PUMP SPECIFICATIONS:       
Moro PM200 liquid cooled vacuum/pressure pump, 678 CFM free air rating, 27"Hg maximum vacuum. Includes hydraulic oil cooler.

PRESSURE UNLOADING SYSTEM:
None

DRIVE:
Hydraulically driven from air shift PTO mounted on transmission with remote mount hydraulic pump and motor.

HYDRAULIC RESERVOIR:
Mounted on hydraulic dump sub-frame with suction strainer, diffuser, fill cap, hydraulic oil filters and sight glass.

HYDRAULIC DUMP SYSTEM:
Full length hydraulic dump sub-frame with 20 ton, 3 stage single acting dump cylinder, rear dump pivot assembly and safety brace.

HYDRAULIC CONTROLS:
3-spool valve body for control of hydraulic dump, rear door and vacuum pump.

GAUGES:
Glycerin filled vacuum/pressure gauge and hydraulic pressure gauge.

SIDE TRAYS:
Full-length side boxes for hose storage / fender assembly with anti-sail mud-flaps and rear tire skirt.                

TRIM:
Ladder assembly, four numbered placards, 50' static line and steel toolbox assembly.

LIGHTING:
DOT LED moisture proof lighting with clearance lamps, reflectors, three in a row clearance markers, upper license plate mount and light assembly, two rear facing rectangular halogen flood lights and one rear amber strobe beacon.

BUMPER:
DOT rear bumper for protection of external valves with platform/step assembly and rear dirt shield.

PAINTING:
The entire tank and body of the vacuum system shall be sandblasted and primed with two (2) coats of primer and painted with two (2) coats of single stage Sherwin Williams paint.

ADDITIONAL ITEMS INCLUDED:
- Dual rear mounted hose hooks.

INSTALLATION:
Complete system installed on a 2016 Peterbilt 348 Chassis, Paccar PX-9 with 350 HP Engine, and Eaton Fuller FRO-11210C 10 speed Manual Transmission

    888-936-4369
    Give Us A Call For More Sales & Rental Information

    All advertised prices exclude government fees and taxes, any finance charges, any dealer document preparation charge, and any emission testing charge. Vehicles are subject to prior sale. All advertised to be true but not guaranteed.