Available Inventory

2014 Vactor HXX HydroExcavator PD

Click Image to Enlarge

General Details:

EQ #:7083
VIN #:1NKDX4TXXEJ406154
Chassis:
2014 Kenworth T800
Engine:
Cummins ISX 15
Vacuum System:
Hibon 8702 Tri-Lobe ( 28" HG ) 5150 CFM
GPM / Pressure:
10 GPM @ 2500 PSI

Specifications:

2014 VACTOR Hydro-Excavator EQ #7083 having Positive Displacement (PD) Blower driven from chassis engine, 12 cubic yard debris  hopper and 1200 gallon water capacity

STANDARD EQUIPMENT
Hydro-Excavator Standard Module

Debris Body
12 Cubic yard volumetric debris body
Cylindrical design, 1/4" abrasion & corrosion resistant Ex-Ten steel
Flat style, 3/4 rear door, hinged at top w/replaceable neoprene seal
Vibrator mounting bracket only
Hydraulic rear door locking system with door grabber
Hydraulic rear door open & close system
6" Knife valve with 10' drain hose, cam-loc connector
8" Inspection port, Top mounted with ladder for easy access
Rear door support for operator safety
Font mounted hydraulic dump cylinder, 50 degree dump angle, power up/power down

Water Tanks
1200 Gallon capacity insulted, structural foam & polyethylene water tank Water tank separate from debris tank
Includes anti-siphon device & anti-splash valve w/25' water fill hose and connectors Water level sight gauge, Mark III electronic low water warning system
5 Year warranty against leaks

Water System   
Water system rated design is 10 gpm @ 2500 psi
Hydraulic operated Tri-plex piston water pump
Water pump on/off located on pendant control and control box
Variable pressure and flow achieved by electronic-over-hydraulic controls at operators station Handgun hose 3/8" x 75' w/operating pressure of 3500 psi and burst pressure of 14,500 psi, located in heated cabinet.

PD Vacuum System
Hibon 8702 Tri-Lobe ( 28" HG ) 5150 CFM @ Max. Speed 2000 RPM
Ultra Quiet Inlet and Outlet Silencers Acoustically Matched to Blower
Direct Drive Omsi Transfer Case
Dual Cyclonic Separators with 12" clean out door
Microstrainer Final Filter with 3" Camlock drain
Vacuum relief located in the inlet of debris tank to allow operator to vent to atmosphere.  Pendant control operated. Remote push button pendant control w/75' cable with a vacuum relief, water on/off and throttle control

Control Panel (Located Passengers Side)
Located inside an aluminum box for protection
Vansco-Electronic Package includes: chassis tachometer, operating mode, PTO mode, hydraulic oil temp indication, water temp indication, and blower temp indication.  E-Stops will disable vacuum, throttle chassis engine to idle, turn off water pump, and disable hydraulics.  E-Stops located at all HMI points (control panel, wireless remote, optional corded pendant).  IntelliView display includes Machine Functions and Diagnostics (Chassis and Module).

Boom & Vacuum Hose
7' Hydraulic extendable boom/top mounted with 320 degrees of rotation 8" I.D. wire reinforced rubber suction hose 
Boom will have an electric-over-hydraulic solenoid system with speed flow control valves Boom will be powered hydraulically up/down/right/left/extend/retract
Boom control, joystick and hand carried pendant control w/75' cable located at operator station All boom inlet hose and tubing will be 8" inside diameter
 
Vacuum Pipe Package
Package will be:
(1) 8" x 7' aluminum fluidizer tube with rubber safety end
(2) 8" x 6' aluminum flanged pipe
(2) 8" x 3' aluminum flanged pipe
(5) 8" quick clamps

All connections between debris body and vacuum system will be self-adjusting, pressure fitting type

Water System/Pipe Package
Includes:
(1) Digging wand
(1) dual nozzle assembly
(1) triple nozzle assembly
Quick couplers and shut-off valve
(3) Extension pipe assemblies totaling 20'


Hydraulic System
Hydraulic reservoir capacity of 50 gallons w/strainers on all suction lines. Oil level sight gauge
Inspection hatch for maintenance
10 micron spin on type filter

Electrical          
Entire system will be moisture and vapor sealed
Electrical connections require no exposure wires or terminals
Light bulbs will be shock mounted
Complete wiring diagram is provided with machine, circuit breakers are supplied

Storage Cabinets
(1) 50"L x 30"D x 30"H Aluminum tool box located behind cab passenger side. Water pump and retractable handgun hose reel will be located in this box.

Mounting
Approved truck chassis

Painting
All metal surfaces shot blasted prior to painting
All metal surfaces will be phosphate washed prior to painting
Coated with a minimum of 2.5 mil primer
Painted with a minimum of 2.5 mil finish paint process

Miscellaneous
Tow hooks front and rear
Mud Flaps
Electronic back-up alarm
Spring Loaded Ground Reel
Fenders
Factory Training and Start Up

Debris Body
Folding Pipe Rack / Street Side
Folding pipe rack, rear door
Rear Door Splash Shield
Lube Manifold
Electric vibrator - debris body mounted
Sludge pump off-load system
Float ball screens - Perforated plastic

Water Tank Accessories
Air Purge System Utilizing Chassis Air System
800,000 B.T.U. Water heater
Cabinet Heater, Drain valve donut heater and Insulation Package

Boom Accessories
7' Hydraulic telescopic boom w/320 degree rotation  Remote push button pendant control with 75' cable with a vacuum relief, water on/off and throttle control

High Pressure Water Pump
12 GPM Cold Weather Recirculation System  Front Crankshaft Driven (Manual Trans. Chassis) Chassis Will Require Front Crank Provision. 20 GPM/2500 psi Single Cat triplex pump (Requires 940K Heater, & Min. 160 Amp alternator)

Hose Reel Accessories
Hydraulic Tool Package

Front Station And Controls
Second operator station:  Includes additional hosereel rear mounted with second handgun, plumbing & fittings.  ( Front and Rear station, 10 gpm water pump is standard.)

Light Accessories
Hand Light W / Retractable Reel
Revolving Light Rear Mounted
Revolving Light Front Mounted 
Work Light At Operators Station (One Only)
Work Lights On Extendable / Telescopic Boom (Two)

Tool Box - Vactor & Chassis Accessories
18" wide x 24" deep x 48" high aluminum tool box, maximum of 2 per truck.  1 - located left side behind tandem, 1 - located right side behind tandem (Recommended Option- 1 Mounted on Right Side ) 104" Long x 22" Deep x 24" High Aluminum Tool Box
18" Wide x 92"D x 52"H Aluminum tool box mounted behind cab w/ slide out drawers
4" Rear Mounted Sludge Pump

Paint
Module - Wet on Wet (Primer base)
BODY COLOR:  White
CAB COLOR:     White

Chassis
2014 Kenworth T800, Cummins ISX 485 HP Engine, Eaton Fuller RTLO Transmission

    888-936-4369
    Give Us A Call For More Sales & Rental Information

    All advertised prices exclude government fees and taxes, any finance charges, any dealer document preparation charge, and any emission testing charge. Vehicles are subject to prior sale. All advertised to be true but not guaranteed.